Section 50 (Front Suspension - 4WD Torsion Bar - "K" Series - New Style): Description
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2000 GMC Yukon XL, 2000 GMC Yukon, 2000 GMC Sierra, 2000 Chevrolet Tahoe, and 2000 Chevrolet Suburban. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
This article applies to 2000-01 new style "K" Series using 4.8L, 5.3L and 6.0L engines. For information on 2000 "K" Series old style, see FRONT - 2WD & 4WD C & K SERIES - OLD STYLE
.
Independent front suspension consists of upper and lower control arms with steering knuckle mounted between ball joints. See Fig 1. Shock absorbers fit between lower control arm and frame. A stabilizer bar is mounted to frame side rails and connected to lower control arms.
Torsion bars are used in place of coil springs. Front of torsion bar attaches to lower control arm. Rear of torsion bar attaches to adjustable arm at torsion bar support crossmember. Adjustments to trim height are made here.