LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2000 >> Eldorado ETC >> Repair and Diagnosis >> Suspension >> Electronic Suspension >> Electronic Suspension - CV Road Sensing >> Diagnostic Tests >> DTC C0695 Or C0696: Position Sensor OVERCURRENT

DTC C0695 Or C0696: Position Sensor OVERCURRENT

  1. Perform diagnostic system check. See DIAGNOSTIC SYSTEM CHECK  . After performing diagnostic system check, go to next step.
  2. Turn ignition switch on. Backprobe suspension control module harness connector and measure voltage from low voltage reference circuit to LR position sensor circuit. See WIRING DIAGRAMS  . If voltage is less than 6 volts, go to step  4 . If voltage is more than 6 volts, go to next step.
  3. If voltage is more than 9 volts, go to step  6 . If measured voltage is less than 9 volts, go to step  7 .
  4. Check each position sensor low voltage reference circuit for a short to ground. If a short to ground was found and repaired, go to step  8 . If a short to ground was not found, go to next step.
  5. Check for a short between the low voltage reference circuit and ground circuit for each position sensor. If a short was found and repaired, go to step  8 . If a short was not found, go to step  7 .
  6. Check each position sensor low voltage reference circuit for a short to voltage. If a short to voltage was found and repaired, go to step  8 . If a short to voltage was not found, go to next step
  7. Replace suspension control module. See ESC/CVRSS CONTROL MODULE  under REMOVAL & INSTALLATION. Calibrate NEW control module. See CALIBRATING ESC/CVRSS CONTROL MODULE  under ADJUSTMENTS. If replacement is complete, go to next step.
  8. Using scan tool, clear DTCs. Operate vehicle under normal driving conditions. If DTC resets, go to step  2 . If DTC does not reset, system is okay.
scientia non olet · About LEMON Manuals