Retrieving Diagnostic Trouble Codes
NOTE:
If vehicle is to be operated in diagnostics without engine running for an extended time period, use battery charger to prevent battery from running down or system setting false diagnostic information. DTC B1982 may set if vehicle is connected to a battery charger on fast or boost charge.
To retrieve DTCs using scan tool, select Instrument Panel Cluster (IPC) data on scan tool. Select DTC function for IPC. Select HISTORY or CURRENT DTC display function to view corresponding codes.
To enter diagnostic mode using on-board diagnostics, turn ignition on. Simultaneously press OFF and passenger warmer buttons on climate control panel. Pressing low (fan speed) button will scroll through modules available. Scroll through until IPC? appears. Pressing high (fan speed) button will scroll through functions of selected module (i.e., IPC DATA, IPC INPUTS, IPC OUTPUTS, etc.). Scroll through until IPC CODES? appears. Press high (fan speed) button until all IPC DTCs appear. Note codes and go to INSTRUMENT PANEL CLUSTER DIAGNOSTIC TROUBLE CODE DEFINITION
table. To exit diagnostic mode, press rear defogger or MODE button on CCP, or turn ignition off. DTCs will not be cleared. System will return to normal vehicle operation.
INSTRUMENT PANEL CLUSTER DIAGNOSTIC TROUBLE CODE DEFINITION
| DTC |
Description |
| B0532 |
Fuel Sensor Shorted To Ground |
| B0533 |
Fuel Sensor Open/Short To Battery |
| B1552 |
Loss of Keep Alive Memory (KAM) |
| B1556 |
IPC EEPROM Odometer Error |
| B1557 |
EEPROM Calibration Error |
| B1910 |
Generator "L" Terminal Open Circuit |
| B1911 |
Generator "L" Terminal Malfunction |
| B1981 |
Source Voltage Low (Engine Running) |
| B1982 |
Device Power 1 Circuit High |
| B1983 |
Device Power 1 Circuit Low |
| B2419 |
Twilight Sentinel Photo Sensor Malfunction |
| B2510 |
Steering Wheel Controls HVAC Key Stuck |
| B2511 |
Steering Wheel Controls Convenience Key Stuck |
| B2515 |
Steering Wheel Controls Illegal Resistance Value |
| B2710 |
PASS-Key(R) II Open/Short Key Pellet |
| B2711 |
PASS-Key(R) II Open/Short Key Pellet |
| B2750 |
PASS-Key(R) II Data Communication Malfunction |
| B2780 |
PASS-Key(R) II Wrong Resistor Value Before Good |
| B2781 |
PASS-Key(R) II Wrong Resistor Value After Good |
| B2782 |
PASS-Key(R) II Pellet Value Not Programmed |
| B2783 |
PASS-Key(R) II Code/Password Corrupted |
| U1016 |
Loss Of Communication With PCM |
| U1040 |
Loss Of Communication With ABS |
| U1064 |
Loss Of Communication With BCM |
| U1088 |
Loss Of Communication With SDM |
| U1144 |
Loss Of Communication With PHN |
| U1152 |
Loss Of Communication With ACM |
| U1153 |
Loss Of Communication With CCP |
| U1000 & U1255 |
Class 2 Communication Malfunction |