LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2000 >> DeVille DTS >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Symptom Tests >> Trunk Open Message Always On

Trunk Open Message Always On

NOTE: Trunk is also referred to as rear compartment.
  1. If body rear end diagnostic system check was performed, go to next step. If body rear end diagnostic system check was not performed, go to appropriate diagnostic system check in POWER TRUNK & FUEL DOOR RELEASE - DEVILLE article.
  2. Turn ignition off. Connect scan tool to Data Link Connector (DLC). See Figure . Close rear compartment lid (trunk). Using scan tool, select Rear Integration Module (RIM) data list. Monitor TRUNK AJAR SWITCH status. If TRUNK AJAR SWITCH status is not OFF, go to next step. If TRUNK AJAR SWITCH status is OFF, check for intermittent connections or circuits.
  3. Turn ignition off. Disconnect rear compartment lid release actuator connector. See COMPONENT LOCATIONS  . Turn ignition on. Monitor TRUNK AJAR SWITCH status. If TRUNK AJAR SWITCH status is not OFF, go to next step. If TRUNK AJAR SWITCH status is OFF, go to step  6 .
  4. Check for short to ground in Red/Black wire between rear compartment lid release actuator and RIM connector C1 terminal B3. See Figure . If circuit is okay, go to next step. If faulty circuit is found and repaired, go to step  9 .
  5. Check for poor connections at RIM connectors. If connections are okay, go to step  7 . If faulty connections are found and repaired, go to step  9 .
  6. Check for poor connections at rear compartment lid release actuator connector. If connections are okay, go to step  8 . If faulty connections are found and repaired, go to step  9 .
  7. Replace RIM. See REAR INTEGRATION MODULE under REMOVAL & INSTALLATION in BODY CONTROL MODULES - DEVILLE article. After repairs, go to step  9 .
  8. Replace rear compartment lid release actuator. See REAR COMPARTMENT LID RELEASE SOLENOID under REMOVAL & INSTALLATION in POWER TRUNK & FUEL DOOR RELEASE - DEVILLE article.
  9. After repairs, recheck operation of TRUNK OPEN message. If TRUNK OPEN message operates properly, repair is complete. If TRUNK OPEN message does not operate properly, go to step  2 .