Steering AUTOCENTER
NOTE:
This procedure requires a Tech 1 scan tool.
- Connect Tech 1 scan tool to Data Link Connector (DLC) located under left side of instrument panel. Enter diagnostics. See SELF-DIAGNOSTICS under DIAGNOSIS & TESTING. Check for CVRSS steering sensor Code C1780. If code is set, diagnose and repair before continuing. Ensure wheels are in straight-ahead position and steering wheel is centered.
- Turn ignition on, engine off. Using scan tool, monitor RSS DATA RS D15. If voltage is not 2-3 volts, realign steering sensor. To adjust steering autocenter, follow instructions on Tech 1 scan tool.