LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 1999 >> Seville STS >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel - Analog >> System Tests >> Gauges >> Fuel Gauge Always Reads Empty

Fuel Gauge Always Reads Empty

  1. Turn ignition switch to ON position. Connect scan tool. Select view Rear Integration Module (RIM) DTCs. If DTC B0530, B0532 or B0533 are current, repair these DTCs first. See SELF-DIAGNOSTIC SYSTEM in BODY CONTROL MODULES - SEVILLE article in ACCESSORIES & EQUIPMENT. If DTCs are not present, go to next step.
  2. Select RIM data function on scan tool. If scan tool indicates fuel tank has less than 11 gal. (41 L), go to next step. If scan tool indicates fuel tank has more than 11 gal. (41 L), go to step  6.
  3. Turn ignition switch to OFF position. Disconnect fuel level sending unit connector. To access fuel level sending unit connector, see FUEL LEVEL SENDER  under REMOVAL & INSTALLATION. Use appropriate dial gauge tester and set to 250 ohms (full). Connect gauge tester between fuel level sender connector terminals "D" (Black/White wire) and "A" (Purple wire). See WIRING DIAGRAMS . Turn ignition on. Wait 4 minutes. If fuel gauge reads FULL, go to step  5. If gauge does not read FULL, go to next step.
  4. Check for poor connections at RIM connector C1 terminals A7 and B3. See WIRING DIAGRAMS . If connections are okay, replace RIM. See REAR INTEGRATION MODULE  under REMOVAL & INSTALLATION. Recheck system operation.
  5. Check for poor connections at fuel level sender connector. Repair if necessary. If connections are okay, replace fuel level sender. See FUEL LEVEL SENDER  under REMOVAL & INSTALLATION. Recheck system operation.
  6. Replace IPC. See INSTRUMENT PANEL CLUSTER  under REMOVAL & INSTALLATION. Recheck system operation.
scientia non olet · About LEMON Manuals