LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 1999 >> Seville STS >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel - Analog >> Removal & Installation >> Instrument Panel Cluster >> Removal & Installation

Removal & Installation

  1. Remove left and right windshield garnish moldings. Remove air outlets. Remove fasteners from inside of vent outer hole to upper pad. Lift upper trim pad upward from rear edge over IP cluster to disengage retainers from IP cluster trim plate. Lift upper trim pad on an angle and slide rearward to disengage front retainers at front of instrument panel.
  2. Remove 2 fasteners on each side of cluster. Disconnect left and right Driver Information Center (DIC) switch electrical connectors. Remove screws from IP cluster. Remove IP cluster from retainer. To install, reverse removal procedure.
scientia non olet · About LEMON Manuals