Stoplight Switch: Installation

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.

Install the electrical connector to the stoplight switch.
Install the stoplight switch and the pushrod to the brake pedal pin. See Fig 1.
Install the pushrod retainer on the brake pedal pin. The retainer will snap into place.

Fig 1: Removing & Installing Stoplight Switch

Courtesy of GENERAL MOTORS CORP.