Code C1710, DTC C1715, DTC C1720 & DTC C1725: Damper Actuator Short Circuit To Battery/Short Across Load

CODE C1710

Left Front Damper Actuator Short Circuit To Battery/Short Across Load

CODE C1715

Right Front Damper Actuator Short Circuit To Battery/Short Across Load

CODE C1720

Left Rear Damper Actuator Short Circuit To Battery/Short Across Load

CODE C1725

Right Rear Damper Actuator Short Circuit To Battery/Short Across Load

Perform CVRSS system check. See CVRSS SYSTEM CHECK . After performing CVRSS system check, go to next step.
Turn ignition off. Disconnect damper actuator connector. Using DVOM, measure resistance between terminals of damper actuator connector (component side). If resistance is 9.5-15.5 ohms, go to next step. If resistance is not 9.5-15.5 ohms, go to step 7).
Turn ignition on, with engine off. Using DVOM, measure voltage at damper ground circuit (Light Blue wire on front; Dark Blue wire on rear) of damper actuator connector (component side). See WIRING DIAGRAMS . If voltage is 10 volts, go to step 7). If voltage is not 10 volts, go to next step.
Turn ignition off. Disconnect 32-pin CVRSS control module connector C3. Turn ignition on, with engine off. Using DVOM, measure voltage at damper control circuit (Gray wire on front; Dark Green wire on rear) of CVRSS control module harness connector C3. See WIRING DIAGRAMS . If voltage is 10 volts, go to step 8). If voltage is not 10 volts, go to next step.
Check continuity between damper control circuit (Gray wire on front; Dark Green wire on rear) and damper ground circuit (Light Blue wire on front; Dark Blue wire on rear) of CVRSS control module harness connector C3. See WIRING DIAGRAMS . Repair as necessary. After repairs, perform CVRSS SYSTEM CHECK . If circuits are okay, go to next step.
Check for intermittents in damper actuator circuits. Turn ignition off. Reinstall/reconnect all components/connectors. Turn ignition on, with engine off. Clear codes, and then wait 90 seconds. Display codes. If Code C1710, C1715, C1720 or C1725 is set, go to step 9). If Code C1710, C1715, C1720 or C1725 is not set, perform CVRSS SYSTEM CHECK .
Replace damper actuator. After repairs, perform CVRSS SYSTEM CHECK .
Repair short to voltage in damper control circuit (Gray wire on front; Dark Green wire on rear). After repairs, perform CVRSS SYSTEM CHECK .
Turn ignition off. Replace CVRSS control module. Reinstall/reconnect all components/connectors. Install scan tool. Turn ignition on, with engine off. Calibrate NEW CVRSS control module. See CALIBRATING CVRSS CONTROL MODULE under ADJUSTMENTS. Perform CVRSS SYSTEM CHECK .