Service Ride Control Message Displayed, No RSS Codes Set: Description
If RSS module loses any of the following inputs, SERVICE RIDE CONTROL message will be displayed, but no RSS codes will be set:
- Battery feed.
- Ignition feed.
- Ground.
- UART data line.
- Each of the above may set Code I039.
NOTE:
Test numbers refer to numbers on diagnostic chart in Fig 2.
- See NOTES ON INTERMITTENTS under TESTING & DIAGNOSIS.
- See the appropriate INSTRUMENT PANEL article in ACCESSORIES/SAFETY EQUIP section.
CAUTION:
DO NOT
backprobe connector terminals at position sensors, dampers, ELC or SSS connectors.
NOTE:
After repairs, clear codes and verify system operation.