IPC Specific Override Displays: Is11

OPTION 3 override allows ability to change vehicle option content information stored in IPC. IPC uses this option to store vehicle body type. IPC communicates this information to SDM over serial data so SDM can determine if it is installed in correct vehicle. If SDM calibration and IPC body type do not match, a calibration error is detected and SDM sets a SIR Code R055. Incorrect OPTION 3 content information will cause SDM to set SIR code R055. Upon selection of this override, option content information will be displayed as a number. To determine proper OPTION 3 number, see OPTION 3 NUMBER  table.