Action Taken

The RSS module stops driving the solenoid within the first one-millisecond sample in which a high feedback is sensed, waits 5 seconds, retries driving the solenoid and re-senses for feedback.

If the feedback is high, the RSS module resumes normal operation. If the feedback is low, the RSS module repeats this "stop-wait-retry/re-sense" sequence. The RSS module increases a software counter for each low feedback observed or decreases it for each high feedback observed. If the counter reaches 3 counts at any time, the RSS module sets a code, turns on the SERVICE RIDE CONTROL message and stops driving the solenoid for the remainder of the ignition cycle.