LOW OIL PRESSURE STOP ENGINE Message
- This message displays when oil pressure switch is closed for more than 2 seconds when engine is running. PCM communicates to IPC that engine is running. If this communication line is lost, a Code I034 will be set. If Code I034 is set when ignition is on and engine is off, IPC will assume engine is running and display message on DIC.
- If Code I034 is not set, and message is displayed when oil pressure is known to be greater than 5 psi at idle, check for short to ground in Tan wire circuit between IPC connector terminal D5 and oil pressure switch. See Figure . Also check for shorted pressure switch.
- If oil pressure is known to be less than 3 psi at engine idle and message does not display, check for open in Tan wire circuit or in Black ground wire circuit from switch.