LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 1988 >> Seville Base >> Repair and Diagnosis >> Suspension >> Rear Suspension >> Suspension - Rear (Fwd) >> Removal & Installation >> Control Arm >> Installation ("E" & "K" Bodies)

Installation ("E" & "K" Bodies)

  1. Install control arm and inner retaining bolts. DO NOT tighten at this time. Install knuckle, strut, hub and rotor assembly. Install knuckle pivot bolt. DO NOT tighten at this time.
  2. Install lower strut insulator and strut. Install upper strut insulator, retainer and nut. Tighten strut retainer nut, knuckle pivot bolt and inner control arm bolts in this sequence to specification.
  3. Reverse removal procedures for remaining components. Tighten bolts to specification. Check and adjust rear wheel alignment.
scientia non olet · About LEMON Manuals