Removal & Installation: Knuckle: Removal
- Raise and support vehicle. Remove wheel and tire assembly. Disconnect ELC height sensor link, if removing left knuckle. Remove stabilizer bar mounting bolt from strut, if equipped. Remove and support caliper. Remove rotor. Remove hub and bearing assembly.
- Loosen, but do not remove knuckle pivot bolt. Remove strut rod cap, mounting nut, retainer and upper insulator. Compress strut by hand and remove lower insulator. Rotate strut and knuckle assembly outward. Remove knuckle pinch bolt. Remove strut from knuckle. Remove knuckle pivot bolt. Remove knuckle from control arm.