Intake Manifold: Removal
- Drain cooling system, remove air cleaner and disconnect all hoses and wiring as necessary. Remove breather pipes and air crossover. Cap intake manifold with cover screens (J-26996-2 for Calif. models, and J-26996-10 for Federal models).
- Disconnect throttle rod, spring and remove servo (if equipped with cruise control). Remove retaining clip from bellcrank. Remove throttle cable from bracket and position away from engine. Remove alternator and A/C brackets as necessary.
- Disconnect fuel lines to fuel pump, filter, nozzles and injection pump. Remove injection pump, fuel filter and brackets. Cap all open fuel lines and fittings.CAUTION: DO NOT bend injection pump lines.
- Disconnect vacuum lines at vacuum pump and remove pump. Remove drain tube, intake manifold bolts and intake manifold. Remove adapter seal and injection pump.