Stop Engine Temperature Indicator

The "Stop Engine Temp" light should come on with key in ignition and door open. A buzzer will sound and light will come on when engine metal temperature exceeds 320°F. The buzzer will stay on until temperature drops below 240°F, even with ignition "OFF".

1. If lamp does not come on, disconnect the light green wire at the sending unit (rear of left cylinder head). If lamp comes on and buzzer sounds, replace sender. If not, check fuse, bulb, and printed circuit connector. Voltage should be present at printed circuit connector.
2. If voltage is present at connector, light green wire is open between sender and lamp. If no voltage, pink wire is open between fuse and printed circuit.
3. If lamp does not go out, disconnect light green wire at sender. If lamp goes out, replace sender. If lamp stays on, green wire is shorted to ground between printed circuit and sender.