Both Seat Backs Will Not Release
- Remove seat back release relay connector located on right side cowl. With a jumper wire, short between light green battery feed wire and dark green solenoid feed wire. If seat backs release, reconnect relay connector and check for voltage between light green wire and yellow wire at under seat connector. With no voltage at yellow wire, trace wire for an open circuit. With voltage at yellow wire, check seat back release relay for operation.
- If seats still do not automatically release, replace connector on relay and check voltage of dark green wire at under seat connector. If voltage is not present at dark green wire, check voltage at circuit breaker, check for open circuit in light green wire leading from circuit breaker or open circuit in red battery feed wire leading to circuit breaker. If voltage is present at under seat connector, follow procedure for one seat not releasing.