Sunroof/Sunshade Motor Initialization

Perform the Initialization/Learn procedure any time:

• A new sunroof motor/actuator has been installed.
• The existing sunroof motor/actuator has been removed and reinstalled.
• The sunroof system has suffered 7 interruptions for emergency events, i.e. anti-pinch, debris in tracks etc., and normal operation is canceled.

By performing the Initialization/Learn procedure, the sunroof motor/actuator records the open vent stop position. The motor/actuator will then understand the other positions, closed and full open soft stop, and allow express and obstacle detection functions.

1. Ensure that all electrical harness connectors are connected.
2. Vehicle ON.
3. Vehicle is not moving.
4. Temperature is between +5 to +45°C (+41 to +113°F).
5. Completely close the sunroof and sunshade with the manual close switches.
6. Press and hold the sunroof slide switch in the closed position for 10 seconds (do not release the switch through movement). The following will occur.
   • The sunroof blind will move to full open position
   • The sunroof will then move to full open position
   • The sunroof will then move to full close position
7. Release the switch.
8. Hold the close sunroof blind switch to achieve full close on sunroof blind.
9. Release the switch.
10. Hold the close sunroof blind switch for 10s, the following will occur (do not release the switch through movement). The following will occur.
    • The sunroof blind will move to full open position
    • The sunroof blind will then move to full close position
11. Release the switch.
IMPORTANT:

The Initialization/Learn procedure is not complete if the vehicle battery power has been interrupted during the process.

The Initialization/Learn Process must be restarted if the procedure is not carried out completely.

12. Verify the operation of the sunroof in all positions.
13. The initialization Process must be repeated in order to re-gain express movements and normal function.