Hood Secondary Latch Release Cable Replacement

Courtesy of GENERAL MOTORS COMPANY

NOTE: Callout items in the following chart represent components shown in graphic above.

Callout	Component Name
Preliminary Procedures Intake Air Splash Shield Replacement
1	Hood Secondary Latch Release Cable Bolt [2x] CAUTION: Refer to Fastener Caution . Tighten 2.5 N.m (22 lb in)
2	Hood Secondary Latch Release Cable Procedure Disconnect the release cable from the hood primary latch. Disconnect the hood secondary latch release cable retainer from the bracket. Align the hood secondary latch release cable latch if necessary.

Callout

Component Name

Hood Secondary Latch Release Cable Bolt [2x]

CAUTION:

Tighten
2.5 N.m (22 lb in)

Hood Secondary Latch Release Cable

Procedure