Air Cleaner Monitor Setup: Description

WARNING: This page is about a different variant/trim than selected.

For an overview of the component/system, refer to: Owner's manual

The Air Cleaner Monitor Setup is used to inform the driver when the next service interval is required. The Air Cleaner Monitor displays the status of the air cleaner, the Air Cleaner Life Remaining and displays the percentage of air cleaner life. The Air Cleaner Monitor Setup can be used to Disable/Enable the monitor and Reset the Air Cleaner Life Remaining percentage

The control module K20 monitors the following:

Air Cleaner Monitor Test Result
Ambient Air Temperature
Distance Traveled
Engine Coolant Temperature
Engine Load
Engine Speed
Humidity Sensor Intake Air Temperature Signal
Time Since Last Service Interval Reset
Total Mass Air Flow
Vehicle Speed

If air cleaner maintenance is required the Replace Filter Now message will be activated when the control module K9 receives a serial data message from the control module K20.

This procedure resets the control module learned values of the component/system: Air Cleaner Monitor