Automatic Transmission Wiring Harness Bracket Replacement (L3T)
WARNING: This page is about a different variant/trim than selected.
 Courtesy of GENERAL MOTORS COMPANY
|
| Callout |
Component Name |
|
Preliminary Procedures
- Battery Tray Replacement
- Engine Mount Brace Replacement (LH, FWD)
|
| 1 |
Transmission Wiring Harness Bracket Bolt [2x]
Tighten
9 N.m (80 lb in) |
| 2 |
Wire Tie Strap
Procedure
Remove and DISCARD the 2 wire tie straps from the bracket. Replace with NEW wire tie straps. |
| 3 |
Transmission Wiring Harness Bracket |