Circuit/System Verification
- Ignition ON/Vehicle in Service Mode.
- Verify a test pattern is displayed is displayed on the P29 Head-Up Display when performing the Head-Up Display Pattern Check on the scan tool.
- If the test pattern is not displayed
Refer to Inoperative Head-Up display Circuit/System Testing.
- Go to next step: If the test pattern is displayed
- If the test pattern is not displayed
- Verify the P29 Head-Up Display performs the following function with the S27 Head-Up Display Switch in the appropriate state:
- DIM + Switch - Head-up display brightness increases
- DIM - Switch - Head-up display brightness decreases
- UP Switch - Head-up display image moves up
- DOWN Switch - Head-up display image moves down
- INFO Switch - Head-up display image changes pages
- If the P29 Head-Up Display does not perform the expected function with the switch in the appropriate state
Refer to Inoperative Head-Up Display Switch Circuit/System Testing.
- Go to next step: If the P29 Head-Up Display performs the expected function with the switch in the appropriate state
- All OK.