Installation Procedure

Courtesy of GENERAL MOTORS COMPANY

Brake Pedal Retainer (1) - Install NEW
Courtesy of GENERAL MOTORS COMPANY

Power Brake Booster Seal (1) - Install
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Align the power brake booster pushrod with the brake pedal retainer.

Power Brake Booster (1) - Install
Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Fastener Caution

Power Brake Booster Bolt (1) - Install and tighten 22 N.m (16 lb-ft) [ 2x ]
Courtesy of GENERAL MOTORS COMPANY

Fuel Injector Wiring Harness Retainer (1) - Secure
Position the heater coolant pump to the transmission case.
Courtesy of GENERAL MOTORS COMPANY

{ If equipped } Heater Coolant Pump Stud (1) - Install - Heater Coolant Pump Replacement

NOTE:

Ensure the brake master cylinder gasket is positioned correctly against the master cylinder mounting flange.

Position the master cylinder to the power brake booster.
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Install NEW nuts.

Brake Master Cylinder Nut (1) - Install and tighten 49 N.m (36 lb-ft) [ 2x ]
Connect the brake fluid level indicator switch electrical connector.
Courtesy of GENERAL MOTORS COMPANY

Brake Pedal Retainer (1) & Brake Pedal (2) @ Power Brake Booster Pushrod - Secure
Brake Pedal Position Sensor - Install - Brake Pedal Position Sensor Replacement
Courtesy of GENERAL MOTORS COMPANY

NOTE:
A small amount of denatured alcohol may be used as a lubricant for assembly.

Power Brake Booster Vacuum Sensor (1) - Install
Power Brake Booster Vacuum Sensor Electrical Connector - Connect
Reposition and install the radiator surge tank. Radiator Surge Tank Replacement