Front Wheel Bearing and Hub Replacement

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Front Wheel Speed Sensor @ Steering Knuckle - Remove Front Wheel Speed Sensor Replacement - Left Side Front Wheel Speed Sensor Replacement - Right Side Front Wheel Drive Half Shaft @ Front Wheel Hub - Separate Front Wheel Drive Half Shaft Replacement - Left Side Front Wheel Drive Half Shaft Replacement - Right Side (AWD) Front Wheel Drive Shaft Replacement - Right Side (FWD) Front Brake Rotor - Remove - Front Brake Rotor Replacement
1	Front Wheel Bearing and Hub Assembly Bolt [ 3x ] CAUTION: This vehicle is equipped with torque-to-yield or single use fasteners. Install a NEW torque-to-yield or single use fastener when installing this component. Failure to replace the torque-to-yield or single use fastener could cause damage to the vehicle or component. Procedure Remove and DISCARD the bolts. If NEW threaded components are being installed, loosen the adhesive using a metal pick or similar tool before proceeding. If threaded components are reused, prepare the threaded components using the following steps: Remove any loose cured adhesive from the external threads of the components using a lint free cloth. Thread the cleaned components into the internal mating threads and remove to loosen trapped cured adhesive. Apply thread locking adhesive to the external threads of the components. Adhesives, Fluids, Lubricants, and Sealers Ensure there are no gaps in the thread locking adhesive once applied to the component. Tighten CAUTION: Refer to Fastener Caution . First Pass: 100 N.m (74 lb-ft) Final Pass: 65 - 75 degrees
2	Front Wheel Bearing and Hub Assembly Procedure Apply grease evenly and ensure complete coverage to the steering knuckle bearing pilot bore only. Adhesives, Fluids, Lubricants, and Sealers NOTE: Avoid applying grease to any other machined surfaces, holes, or threads. Ensure the drain channel at the bottom of the bore is not blocked with grease or debris.

Callout

Component Name

Preliminary Procedures

Front Wheel Speed Sensor @ Steering Knuckle - Remove
- Front Wheel Speed Sensor Replacement - Left Side
- Front Wheel Speed Sensor Replacement - Right Side
Front Wheel Drive Half Shaft @ Front Wheel Hub - Separate
Front Brake Rotor - Remove - Front Brake Rotor Replacement

Front Wheel Bearing and Hub Assembly Bolt [ 3x ]

CAUTION:

This vehicle is equipped with torque-to-yield or single use fasteners. Install a NEW torque-to-yield or single use fastener when installing this component. Failure to replace the torque-to-yield or single use fastener could cause damage to the vehicle or component.

Procedure

Remove and DISCARD the bolts.
If NEW threaded components are being installed, loosen the adhesive using a metal pick or similar tool before proceeding. If threaded components are reused, prepare the threaded components using the following steps:
1. Remove any loose cured adhesive from the external threads of the components using a lint free cloth.
2. Thread the cleaned components into the internal mating threads and remove to loosen trapped cured adhesive.
3. Apply thread locking adhesive to the external threads of the components. Adhesives, Fluids, Lubricants, and Sealers
4. Ensure there are no gaps in the thread locking adhesive once applied to the component.

Tighten

CAUTION:

Refer to Fastener Caution .

First Pass: 100 N.m (74 lb-ft)
Final Pass: 65 - 75 degrees

Front Wheel Bearing and Hub Assembly
Procedure
Apply grease evenly and ensure complete coverage to the steering knuckle bearing pilot bore only. Adhesives, Fluids, Lubricants, and Sealers

NOTE:

Avoid applying grease to any other machined surfaces, holes, or threads. Ensure the drain channel at the bottom of the bore is not blocked with grease or debris.