LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2020 >> Regal GS >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Hydraulic Brakes >> Repair Instructions >> Front Brake Hose Replacement (J17) >> Removal Procedure

Removal Procedure

WARNING:

Brake Dust Warning

WARNING:

Brake Fluid Irritant Warning

  1. Raise and support the vehicle. Lifting and Jacking the Vehicle
  2. Remove the tire and wheel assembly. Tire and Wheel Removal and Installation
  3. GM4235921Courtesy of GENERAL MOTORS COMPANY

    Brake Pipe Fitting (1) - Disconnect

  4. Cap the brake pipe fitting to prevent brake fluid loss and contamination.
  5. GM4235931Courtesy of GENERAL MOTORS COMPANY

    Brake Hose Retainer (1) - Remove

  6. GM4736979Courtesy of GENERAL MOTORS COMPANY

    Wheel Speed Sensor Harness Clip (1) @ Front Brake Hose - Release [2x]

  7. GM4736985Courtesy of GENERAL MOTORS COMPANY

    Bolt (1) - Remove

  8. GM4736996Courtesy of GENERAL MOTORS COMPANY

    Brake Hose Fitting Bolt (1) - Remove

  9. GM4737002Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Do NOT reuse the brake hose fitting gaskets.

    Brake Hose Fitting Gasket (1) @ Brake Hose (2) - Remove and DISCARD [2x]

  10. Cap the brake caliper inlet port to prevent brake fluid loss and contamination.
  11. Remove the brake hose.
scientia non olet · About LEMON Manuals