Removal Procedure

Courtesy of GENERAL MOTORS COMPANY

NOTE:
Pull the brake pedal rearward to disconnect the retainer from the power brake booster pushrod.

Brake Pedal (1) - Disconnect
Power Brake Booster Vacuum Sensor Electrical Connector - Disconnect
Courtesy of GENERAL MOTORS COMPANY

Power Brake Booster Vacuum Sensor (1) - Remove
Brake Master Cylinder Replacement - Remove
Electronic Brake Control Module with Brake Pressure Modulator Valve Replacement - Remove
Courtesy of GENERAL MOTORS COMPANY

Power Brake Booster Bolt (1) - Loosen [2x]
Courtesy of GENERAL MOTORS COMPANY

Power Brake Booster (1) - Remove
Power Brake Booster Gasket (2) - Remove
Power Brake Booster Gasket - Inspect for damage