Inside Rearview Mirror Replacement (With UHX)

Fig 1: Inside Rearview Mirror (With UHX) Components Location With Torque Specification

Courtesy of GENERAL MOTORS COMPANY

TIGHTENING TORQUE SPECIFICATIONS

Callout	Component Name
Preliminary Procedure Windshield Multifunction Sensor Mount Bracket Cover Replacement (With UHX) , or Windshield Multifunction Sensor Mount Bracket Cover Replacement (Without UHX)
1	Inside Rearview Mirror Set Screw CAUTION: Refer to Fastener Caution . Procedure Loosen the set screw located at the base of the mirror. Tighten 1.8 N.m (16 lb in)
2	Inside Rearview Mirror Procedure Slide the mirror off the rearview mirror button. Disconnect the electrical connector.

Callout

Component Name

Inside Rearview Mirror Set Screw

CAUTION:

Procedure
Loosen the set screw located at the base of the mirror.
Tighten
1.8 N.m (16 lb in)

Inside Rearview Mirror

Procedure