LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2019 >> Regal TourX Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 154 (Automatic Transmission - 9T50 (M3D) And 9T60 (M3T) - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> Drive and Driven Sprocket, Drive Link, and Park Pawl Installation >> Drive Sprocket, Driven Sprocket, and Drive Link Installation

Drive Sprocket, Driven Sprocket, and Drive Link Installation

WARNING: This page is about a different car, the 2020 Buick Regal and 2019 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
GM4376111Courtesy of GENERAL MOTORS COMPANY
Drive Sprocket, Driven Sprocket, and Drive Link Installation

Callout Component Name
1 Driven Sprocket Bearing
2 Driven Sprocket
NOTE:
  • Install the drive link with the colored links and/or part number facing up.
  • The drive link, drive, and driven sprocket assemblies must be installed at the same time.
  • The driven sprocket ball bearing inner race has a slight interference fit with the case. Tap gently with the palm of a hand or a soft tip hammer to install.
  • The ball bearing should spin freely and smoothly.
3 Drive Link
4 Drive Sprocket
5 Drive Sprocket Retaining Ring
6 Drive Sprocket Thrust Washer
scientia non olet · About LEMON Manuals