Installation Procedure
WARNING: This page is about a different car, the 2020 Buick Regal and 2019 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
- Push the engine/transmission unit far enough forward to get space for the installation of the transmission rear mount through bolt.
Transmission Rear Mount (2) - Install
- Install the transmission rear mount through bolt (1).
- Release the engine/transmission unit to bring it into original position.
- CAUTION:
Tighten the transmission rear mount through bolt (1) to 100 N.m (74 lb ft).
- CAUTION:
Install the 2 NEW transmission rear mount bolts (1) and tighten a first pass to 100 N.m (74 lb ft).
- Tighten the 2 NEW transmission rear mount bolts a final pass to 120 - 135 degrees, using the EN-45059 meter.
- Front Compartment Air Deflector - Install - Front Compartment Air Deflector Replacement
- Charge Air Cooler Inlet Air Tube - Install - Charge Air Cooler Inlet Air Tube Replacement
- Transmission Front Mount - Install - Transmission Front Mount Replacement
- Propeller Shaft - Install - Propeller Shaft Replacement
- Exhaust Front Pipe - Install - Exhaust Front Pipe Replacement (LTG AWD) , or Exhaust Front Pipe Replacement (LTG FWD)
- Charge Air Cooler Outlet Air Tube - Install - Charge Air Cooler Outlet Air Tube Replacement
- Lower the vehicle.
NOTE:
A second technician is required.