Installation Procedure

WARNING: This page is about a different car, the 2020 Buick Regal and 2019 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

Transmission Rear Mount (2) - Install
Install the transmission rear mount through bolt (1) finger tight at this time.
Install the transmission rear mount bracket, transmission rear mount and transmission rear mount through bolt as an assembly to the vehicle.
Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Torque-to-Yield Fastener Caution

Install and tighten the 3 NEW transmission rear mount bracket bolts (1).
1. First Pass: 100 N.m (74 lb ft)
2. Final Pass: 60 - 75 degrees - Use the special tool: EN-45059 Angle Meter
Courtesy of GENERAL MOTORS COMPANY

Install and tighten the 2 NEW transmission rear mount bolts (1).
1. First Pass: 100 N.m (74 lb ft)
2. Final Pass: 120 - 135 degrees - Use the special tool: EN-45059 Angle Meter
Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Fastener Caution

Tighten the transmission rear mount through bolt (1) to 100 N.m (74 lb ft).
Front Compartment Air Deflector - Install - Front Compartment Air Deflector Replacement
Lower the vehicle. Lifting and Jacking the Vehicle