LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2019 >> Regal TourX Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 146 (Automatic Transmission - 9T50 (M3D) And 9T60 (M3T) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Transmission Mount Strut Bracket Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2020 Buick Regal and 2019 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
  1. GM4487992Courtesy of GENERAL MOTORS COMPANY

    Install the rear transmission mount bracket (3).

    2. CAUTION:

    Refer to Fastener Caution .

  2. Install the 4 NEW rear transmission mount bracket to transmission bolts (2) and tighten to 100 N.m (74 lb ft) plus 60 - 75 degrees.
  3. Install the NEW rear transmission mount bracket to rear mount through bolt (1) and tighten to 70 N.m (52 lb ft) plus 90 - 105 degrees.
  4. Remove the jack stand.
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals