LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2019 >> Regal TourX Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 146 (Automatic Transmission - 9T50 (M3D) And 9T60 (M3T) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Transmission Mount Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2020 Buick Regal and 2019 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
  1. GM4940174Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Engine Control Module Bracket removed for clarity.

    Install the left transmission mount (5) to the vehicle.

    2. CAUTION:

    Refer to Fastener Caution .

  2. Transmission Mount Bolt (4) - Install and tighten [2x] 100 N.m (74 lb ft)
    3. CAUTION:

    Refer to Torque-to-Yield Fastener Caution .

  4. Transmission Mount Transmission Side Bolt (3) - Install NEW and tighten [4x]
    1. First Pass: 100 N.m (74 lb ft)
    2. Final Pass: 60-75 Degrees
  5. Position the transmission mount bracket (2) to the vehicle.
  6. Engine Mount Brace Bolt (1) - Install and tighten [2x] 22 N.m (16 lb ft).
  7. Remove the transmission jack.
  8. Install the engine wiring harness fuse block bracket. Engine Wiring Harness Fuse Block Bracket Replacement
  9. Install the air cleaner bracket. Air Cleaner Bracket Replacement
scientia non olet · About LEMON Manuals