LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2019 >> Regal TourX Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 146 (Automatic Transmission - 9T50 (M3D) And 9T60 (M3T) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Transmission Control Replacement (Without Base) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2020 Buick Regal and 2019 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
  1. Set the parking brake.
  2. Front Floor Console - Remove Front Floor Console Replacement .
  3. GM4197275Courtesy of GENERAL MOTORS COMPANY

    Disconnect the automatic transmission range selector lever cable terminal (2) from the shift lever pin.

  4. Release the automatic transmission range selector lever cable retainer (1) and remove the automatic transmission range selector lever cable.
  5. Disconnect the transmission control electrical connector.
  6. GM4489334Courtesy of GENERAL MOTORS COMPANY

    Remove the main shaft bolt nut and washer (1) from the transmission control assembly.

  7. GM4489340Courtesy of GENERAL MOTORS COMPANY

    Remove the main shaft bolt (1).

  8. GM4489344Courtesy of GENERAL MOTORS COMPANY

    Pull the transmission control assembly (1) rearward and upward to unseat it from the transmission control base.

  9. Remove the transmission control assembly from the vehicle.