LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2019 >> Regal TourX Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 146 (Automatic Transmission - 9T50 (M3D) And 9T60 (M3T) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Manual Shift Detent Lever Shaft Replacement

Manual Shift Detent Lever Shaft Replacement

WARNING: This page is about a different car, the 2020 Buick Regal and 2019 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
GM4492690Courtesy of GENERAL MOTORS COMPANY
Callout Component Name

Preliminary Procedures

  1. Automatic Transmission Range Selector Lever Cable Replacement 
  2. Control Valve Body Replacement 
1 Manual Shaft Detent Lever Hub Pin
CAUTION:

Refer to Fastener Caution .


Procedure 
Install the manual shaft detent lever hub pin to correct height.
NOTE:

Install a NEW manual shaft detent lever hub pin.


Specification 
7.9 mm (0.38 in) (a)
2 Manual Shaft
NOTE:

Lubricate the shaft with ATF to prevent damage to the manual shift shaft seal during installation.
3 Manual Shaft Detent Lever Assembly
4 Park Pawl Actuator
scientia non olet · About LEMON Manuals