Removal Procedure
WARNING: This page is about a different car, the 2020 Buick Regal and 2019 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
- Battery Tray - Remove - Battery Tray Replacement
- Charge Air Cooler Outlet Air Tube - Remove - Charge Air Cooler Outlet Air Tube Replacement
Input Speed Sensor Electrical Connector (1) - Disconnect
- Electrical Connector (3) @ Engine Coolant Fan - Disconnect
- Wiring Harness Retainer (2) @ Transmission Case - Remove
- Wiring Harness Retainer (4) @ Transmission Control Module Bracket - Remove
- Wiring Harness Retainer (6) @ Control Valve Body Cover Stud - Remove
- Wiring Harness (5) - Position aside
Electrical Connector (1) @ Transmission Control Module - Disconnect
- Electrical Connector (2) @ Transmission - Disconnect
- Wiring Harness Retainer (3) @ Transmission Control Module Bracket - Remove
- Wiring Harness (4) - Position aside
Battery Negative Cable Ground Bolt (2) - Remove
- Battery Negative Cable (1) - Position aside
- Transmission Fluid Cooler Inlet Pipe @ Transmission - Remove - Transmission Fluid Cooler Inlet Pipe Replacement (9T50/9T60)
- Transmission Fluid Cooler Outlet Pipe @ Transmission - Remove - Transmission Fluid Cooler Outlet Pipe Replacement (9T50/9T60)
- Transmission Control Module Bracket - Remove - Transmission Control Module Bracket Replacement
- Transmission Fluid - Drain - Transmission Fluid Drain and Fill
-
Control Valve Body Cover Stud (2) - Remove [6x]
- Control Valve Body Cover Bolt (3) - Remove [6x]
- Control Valve Body Cover (1) - Remove
- Control Valve Body Cover Gasket - Remove and DISCARD
- Remove all traces of the old gasket material. Clean the transmission case and control valve body cover gasket surfaces.