LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2019 >> Regal TourX Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 146 (Automatic Transmission - 9T50 (M3D) And 9T60 (M3T) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Automatic Transmission Range Selector Lever Cable Lever Replacement (LTG Engine) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2020 Buick Regal and 2019 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
  1. GM4486771Courtesy of GENERAL MOTORS COMPANY
    WARNING:

    Hold the transmission range selector lever while removing or installing the lever retaining nut. Failure to hold the lever can cause damage to the transmission internal park system components which could allow the vehicle to roll when placed in the park position.

    Install the automatic transmission range selector lever (2).

    2. CAUTION:

    Refer to Fastener Caution .

  2. Install the automatic transmission range selector lever nut (1) and tighten to 30 N.m (22 lb ft).
  3. Connect the automatic transmission range selector lever cable terminal to the transmission manual shift lever pin. Automatic Transmission Range Selector Lever Cable Replacement 
  4. Check the range selector cable adjustment. Range Selector Lever Cable Adjustment 
  5. Install the battery tray. Battery Tray Replacement
scientia non olet · About LEMON Manuals