LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2019 >> Regal TourX Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 146 (Automatic Transmission - 9T50 (M3D) And 9T60 (M3T) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Automatic Transmission Fluid Pan Drain Plug Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2020 Buick Regal and 2019 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
  1. GM4486476Courtesy of GENERAL MOTORS COMPANY

    Lower the vehicle.

    2. NOTE:

    If the transmission fluid filler cap cannot be accessed, proceed to the next step in this procedure.

  2. Remove the fluid fill cap (1), if accessible.
  3. Remove the left front tire and wheel assembly. Tire and Wheel Removal and Installation
  4. Fig 1: Identifying Transmission Fluid Filler Plug
    GM4487151Courtesy of GENERAL MOTORS COMPANY

    Remove the fluid filler plug (1) from the transmission.

  5. Fill the transmission to the proper level with the correct fluid. Refer to Transmission Fluid Level and Condition Check , and Adhesives, Fluids, Lubricants, and Sealers .
  6. GM4486476Courtesy of GENERAL MOTORS COMPANY

    Install the fluid fill cap (1), if accessible.

  7. Fig 2: Identifying Transmission Fluid Filler Plug
    GM4487151Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Component Fastener Tightening Caution

    Install the fluid filler plug (1) to the transmission and tighten to 40 N.m (30 lb ft).

  8. Install the left front tire and wheel assembly. Tire and Wheel Removal and Installation
scientia non olet · About LEMON Manuals