LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2019 >> Regal TourX Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 143 (Engine Mechanical - 3.6L (LGX) - Repair Instructions) >> Repair Instructions >> Engine Front Cover Removal >> Front Cover Removal

Front Cover Removal

WARNING: This page is about a different car, the 2020 Buick Regal and 2019 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
GM5131790Courtesy of GENERAL MOTORS COMPANY
Camshaft Position Actuator Control Valve and Belt Idler Pulley Removal

Callout Component Name
1 Electrical Connector
NOTE:
  • The retaining clips attached to the oil pump flow control solenoid wire are used for initial production only and should be removed and discarded.
  • The oil pump flow control solenoid may be different depending on model.
2 Engine Front Cover
CAUTION:

Do not pry against the face of the camshaft position actuators or the position actuator retaining bolts as the position actuators will be damaged.


Procedure 
Locate pry points to aid in loosening the cover.
3 Engine Front Cover Locating Pin [2x]
scientia non olet · About LEMON Manuals