Front Cover Installation

WARNING: This page is about a different car, the 2020 Buick Regal and 2019 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedure Ensure proper use of room temperature vulcanizing (RTV) sealant. Use of Room Temperature Vulcanizing (RTV) and Anaerobic Sealant
1	Engine Front Cover Locating Pin [2x]
2	Engine Front Cover Procedure Install the EN-46109 Guide Pins Install the engine front cover. Loosely install the engine front cover bolts. Remove the EN-46109 Guide Pins Special Tools EN-46109 Guide Pins Equivalent regional tools: Special Tools
3	Electrical Connector NOTE: The retaining clips attached to the oil pump flow control solenoid wire are used for initial production only and should be removed and discarded. The oil pump flow control solenoid may be different depending on model.