Cylinder Head Measurement
WARNING: This page is about a different car, the 2020 Buick Regal and 2019 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
Deck Flatness Inspection
Ensure the cylinder head decks are clean and free of gasket material.
- Inspect the surface for any imperfections or scratches that could inhibit proper cylinder head gasket sealing.
- Place a straight-edge diagonally across the cylinder head deck face surface.
- Measure the clearance between the straight-edge and the cylinder head deck face using a feeler gauge at 4 points along the straight-edge.
- If the warpage is less than 0.05 mm (0.002 in), the cylinder head deck surface does not require resurfacing.
- If the warpage is between 0.05 - 0.20 mm (0.002 - 0.008 in) or any imperfections or scratches that could inhibit proper cylinder head gasket sealing are present, the cylinder head deck surface requires resurfacing.
- If resurfacing is required the maximum amount that can be removed is 0.25 mm (0.010 in).
- If the cylinder head deck surface requires more than 0.25 mm (0.010 in) material removal the head must be replaced.
Valve Guide Measurement
Measure the valve stem (1) -to-guide (2) clearance. Excessive valve stem-to-guide clearance may cause an excessive oil consumption and may also cause a valve to break. Insufficient clearance will result in noisy and sticky functioning of the valve and will disturb the engine assembly smoothness.
- Clamp the GE - 8001 Dial Indicator Set to the cylinder head at the camshaft cover rail.
- Locate the dial indicator so that the movement of the valve stem from side to side, crossways to the cylinder head, will cause a direct movement of the indicator stem. The dial indicator stem must contact the side of the valve stem just above the valve guide.
- Drop the valve head about 0.064 mm (0.0025 in) off the valve seat.
- Use light pressure when moving the valve stem from side to side in order to obtain a clearance reading. Engine Mechanical Specifications
- If the clearance for the valve is greater than specifications and a new standard diameter valve stem will not bring the clearance within specifications, the valve guide may be oversized by 0.075 mm (0.003 in) using the EN - 42096 Valve Guide Reamer. There is 1 size of oversized valve stem available for service.
- Valve guide wear at the bottom 10 mm (0.390 in) of the valve guide is not significant to normal operation.
- If oversizing the guide does not bring the clearance within specifications, replace the cylinder head.
Plug Inspection