Crankshaft Balancer Removal
WARNING: This page is about a different car, the 2020 Buick Regal and 2019 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
 Courtesy of GENERAL MOTORS COMPANY
|
| Callout |
Component Name |
|
Preliminary Procedure
- Install the EN - 46106
Flywheel Holding Tool through the starter mounting hole.
NOTE:
The top starter hole will require a longer bolt and nut to secure the tool.
- Remove and discard the crankshaft balancer bolt.
- Install the EN - 44226 - 5
Crankshaft Button in the nose of the crankshaft.
- Install the EN - 25031
3 Jaw Puller
NOTE:
Use the EN - 41816
Crankshaft Balancer Remover with the extension arms removed as an alternate method for removing the crankshaft balancer.
- Tighten the center bolt of the EN - 25031
3 Jaw Puller in order to pull the crankshaft balancer off of the crankshaft.
- Remove the EN - 25031
3 Jaw Puller remover from the crankshaft balancer.
- Remove the EN - 46106
Flywheel Holding Tool through the starter mounting hole.
Special Tools
- EN - 25031
3 Jaw Puller
- EN - 41816
Crankshaft Balancer Remover
- EN - 44226 - 5
Crankshaft Button
- EN - 46106
Flywheel Holding Tool
Equivalent regional tools: Special Tools |
| 1 |
Crankshaft Balancer Bolt
Procedure
Remove and DISCARD the bolt. |
| 2 |
Crankshaft Balancer |