Camshaft Bearing Cap Sequence

WARNING: This page is about a different car, the 2020 Buick Regal and 2019 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Camshaft Bearing Cap Bolts With Tightening Sequence - Right Side

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
1	Camshaft Bearing Cap Bolt [14x] CAUTION: Refer to Fastener Caution . Tighten in sequence First Pass: 6 N.m (53 lb in) Final Pass: 60 degrees
2	Camshaft Carrier Bolt [4x] Tighten in sequence First Pass: 6 N.m (53 lb in) Final Pass: 45 degrees
3	Camshaft Bearing Cap Bolt Tighten in sequence First Pass: 6 N.m (53 lb in) Final Pass: 45 degrees

Callout

Component Name

Camshaft Bearing Cap Bolt [14x]

CAUTION:

Refer to Fastener Caution .

Tighten in sequence

First Pass: 6 N.m (53 lb in)
Final Pass: 60 degrees

Camshaft Carrier Bolt [4x]

Tighten in sequence

First Pass: 6 N.m (53 lb in)
Final Pass: 45 degrees

Camshaft Bearing Cap Bolt

Tighten in sequence

First Pass: 6 N.m (53 lb in)
Final Pass: 45 degrees