LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2019 >> Regal TourX Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 143 (Engine Mechanical - 3.6L (LGX) - Repair Instructions) >> Repair Instructions >> Camshaft Carrier Installation - Right Side

Camshaft Carrier Installation - Right Side

WARNING: This page is about a different car, the 2020 Buick Regal and 2019 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Camshaft Carrier Components - Right Side With Tightening Sequence
GM4025129Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
1 Sealant
CAUTION:

Do not apply more room temperature vulcanization (RTV) silicone than specified. Excess RTV silicone could plug up oil passage holes in the camshaft carrier and lead to engine damage.

Procedure

  1. Ensure proper use of room temperature vulcanizing (RTV) sealant. Use of Room Temperature Vulcanizing (RTV) and Anaerobic Sealant
  2. Place a 3 mm (0.118 in) bead of RTV sealant on the bottom of the camshaft carrier, following the specific bead path.
  3. Place a 5 mm (0.197 in) bead of RTV sealant on the bottom of the camshaft carrier as arrows show. Adhesives, Fluids, Lubricants, and Sealers f
NOTE:

Camshaft carrier surfaces should be free and clean of oil and foreign substances.
2 Camshaft Carrier- Right Side
3 Camshaft Carrier Bolt
CAUTION:

Refer to Fastener Caution .

Tighten in sequence

  1. First Pass: 6 N.m (53 lb in)
  2. Final Pass: 60 degrees
scientia non olet · About LEMON Manuals