LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2019 >> Regal TourX Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 140 (Automatic Transmission - 9T50 (M3D) And 9T60 (M3T) - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> DTC P0658, P0659, P2727, P2729, P2730, P2736, P2738, P2739, P2826, P2827, P282F, or P2830 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2020 Buick Regal and 2019 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition/Vehicle - On
  2. Engine - Running
  3. Verify the scan tool parameter:
    • High Side Driver 1 Circuit Open Test Status = Not Run or OK
    • High Side Driver 1 Circuit Low Voltage Test Status = Not Run or OK
    • High Side Driver 1 Circuit High Voltage Test Status = Not Run or OK
    • Transmission Control Solenoid Valve 5, 6, 9, 10 Control Circuit Open Test Status = Not Run or OK
    • Transmission Control Solenoid Valve 5, 6, 9, 10 Control Circuit Low Voltage Test Status = Not Run or OK
    • Transmission Control Solenoid Valve 5, 6, 9, 10 Control Circuit High Voltage Test Status = Not Run or OK
    • If not the specified state 

      Refer to: Circuit/System Testing

    • Go to next step: If the specified state 
  4. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.

    Verify the DTC does not set.

    • If the DTC sets 

      Refer to: Circuit/System Testing

    • Go to next step: If the DTC is not set 
  5. All OK.
scientia non olet · About LEMON Manuals