LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2019 >> Regal TourX Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 139 (Engine Controls And Fuel - 3.6L (LGX) - Diagnostic Information And Procedures (P0449-P3436) And Symptoms) >> Diagnostic Information and Procedures >> DTC P1255 >> Circuit/System Description

Circuit/System Description

WARNING: This page is about a different car, the 2020 Buick Regal and 2019 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.

For an overview of the component/system, refer to: Fuel System Description

Component Description
K111 Fuel Pump Driver Control Module The control module K111 monitors the fuel system for any condition which may adversely affect emissions. If a condition is detected it sets a DTC and sends a serial data message to the engine control module which then sets DTC P069E.

When the ignition is turned On, the ECM sends a 12 V signal to the control module K111 to enable the fuel pump. If the engine is not started, the control module K111 turns the fuel pump Off after 6 s.