LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2019 >> Regal TourX Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 139 (Engine Controls And Fuel - 3.6L (LGX) - Diagnostic Information And Procedures (P0449-P3436) And Symptoms) >> Diagnostic Information and Procedures >> DTC P0627-P0629 or P12A6 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2020 Buick Regal and 2019 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition - On / Vehicle - In Service Mode
  2. Verify the scan tool parameter:
    • Fuel Pump Enable Circuit High Voltage Test Status = OK or Not Run
    • Fuel Pump Enable Circuit Low Voltage Test Status = OK or Not Run
    • Fuel Pump Enable Circuit Open Test Status = OK or Not Run
    • If not the specified state 

      Refer to: Circuit/System Testing

    • Go to next step: If the specified state 
  3. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
  4. Verify the DTC does not set.
    • If the DTC sets 

      Refer to: Circuit/System Testing

    • Go to next step: If the DTC is not set 
  5. All OK.
scientia non olet · About LEMON Manuals