Circuit/System Verification

Without TC2

1. Ignition ON.
2. Verify the scan tool Liftgate Rear Close Switch parameter changes between Inactive to Active when pressing the B70 Liftgate Close Switch.
   • If the parameter does not change 

     Refer to Circuit/System Testing

   • Go to next step: If the parameter does change 

     Go to next step: Refer to Circuit/System Testing

With TC2

1. Ignition - On / Vehicle - In Service Mode
2. Operate the component:Liftgate - Closed

   Verify the scan tool parameter:Rear Closure Ajar Switch=Inactive

   • If not the specified state 

     Refer to: Circuit/System Testing Rear Hatch/Gate Ajar Indicator Malfunction (With TB5)Rear Hatch/Gate Ajar Indicator Malfunction (Without TB5)

   • Go to next step: If the specified state 
3. Operate the component:Liftgate - Ajar

   Verify the scan tool parameter:Rear Closure Ajar Switch=Active

   • If not the specified state 

     Refer to: Circuit/System Testing Rear Hatch/Gate Ajar Indicator Malfunction (With TB5)Rear Hatch/Gate Ajar Indicator Malfunction (Without TB5)

   • Go to next step: If the specified state 

     Go to next step: Refer to: Circuit/System Testing