Circuit/System Verification

Without UDV

1. Ignition ON.
2. Verify the fuel level gauge sweeps when performing the scan tool Instrument Cluster Gauge Sweep control function.
   • If the fuel level gauge does not sweep 

     Replace the P16 Instrument Cluster

   • Go to next step: If the fuel level gauge sweeps 
3. Verify the low fuel level indicator turns ON and OFF when commanding the scan tool All Indicators control function ON and OFF.
   • If the low fuel level indicator does not turn ON and OFF 

     Replace the P16 Instrument Cluster

   • Go to next step: If the low fuel level indicator turns ON and OFF 
4. Verify the scan tool Fuel Level Sensor parameter is between 0.5 - 3.5 V and varies with fuel level.
   • If not between 0.5 - 3.5 V or does not vary with fuel level 

     Refer to Circuit/System Testing

   • Go to next step: If between 0.5 - 3.5 V and varies with fuel level 
5. All OK.

With UDV

1. Ignition ON.
2. Verify the scan tool Fuel Level Sensor parameter is between 0.5 - 3.5 V and varies with fuel level.
   • If not between 0.5 - 3.5 V or does not vary with fuel level 

     Refer to Circuit/System Testing

   • Go to next step: If between 0.5 - 3.5 V and varies with fuel level 
3. All OK.