LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2018 >> Envision Preferred, AWD >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Bumpers And Fascias >> Repair Instructions >> Rear Bumper Fascia Replacement (Single Exhaust)

Rear Bumper Fascia Replacement (Single Exhaust)

GM4520481Courtesy of GENERAL MOTORS COMPANY
Callout Component Name

Preliminary Procedures

  1. Rear Wheel Opening Molding Replacement
  2. Rear Wheelhouse Liner Replacement
1 Rear Bumper Fascia Pad Bolt [2x]
CAUTION:

Refer to Fastener Caution .


Tighten 
2.5 N.m (22 lb in)
2 Liftgate Adjust Bumper Pad [2x]
3 Rear Bumper Fascia Bolt [4x]
Tighten 
2.5 N.m (22 lb in)
4 Rear Bumper Fascia

Procedure

  1. Carefully push a small nylon wedge between the fascia and the rear fascia guide. Insert a small flat-bladed tool into the fascia slot and depress the snaps one at a time and pull on the fascia at the same time to gradually remove the fascia from the rear fascia guide.
  2. Disconnect all electrical connectors.
  3. Transfer components as necessary.
scientia non olet · About LEMON Manuals